Philips Mixer Grinder 3 Jar 750W Turbo Motor - HL7756/01

The appliance is equipped with an ‘Overload Protector’ (OLP) Switch

If the overload protector switch is activated, the appliance will cut off the power supply. This may happen if the appliance is run continuously for a very long time or if it is overloaded with ingredients.

To reset the appliance:

1. Unplug the appliance.

2. Remove the jar and look under the appliance.

3. On the bottom of the basic unit you see a red switch (OLP). Press the switch to reset the appliance.

4. Let the appliance cool for 2-3 minutes.

5. Reassemble the appliance, plug it back in and switch it on.

1. The appliance may produce some smoke when you use it for the first time. It is normal for a new product to produce an unpleasant smell or emit some smoke when it is first used. This phenomenon stops after you have used the appliance a few times.

2. The appliance may have been running for too long.

Switch off and unplug the appliance immediately

Let the appliance cool down for 60 minutes

Plug the appliance in again and switch the appliance on again

If the problem persists, please contact your local Philips dealer or an authorized Philips service centre.

1) You can clean the appliance by wiping the basic unit with a damp cloth and a non-abrasive liquid cleaner.

2) To clean the jars, follow the instructions given below:

Fill the jar with soapy water

Assemble the jar on the basic unit

Use the ‘WHIP’ button 5-6 times

Wash the jar with clean water

Make sure that you dry the jar and lid completely using a towel before you store it

3) You can clean the other attachments like the spatula and removable blades, with your dishes using soapy water.

When you are grinding a small amount of ingredients, they may get stuck to the sides of the jar.

In that case you must:

1. Switch off the appliance

2. Open the jar

3. Remove the ingredients that are blocking the blade unit with a spatula or by adding some liquid

4. Close the jar and switch the appliance on again to ensure that the ingredients are processed equally

If you notice any trouble in atta kneading, Do not worry and follow few important tips.

Before atta kneading, Apply little food oil on bowl surface, It helps in smooth atta kneading and no material remain stick on bowl surface

Always clean the atta bowl properly after every usage, Otherwise a uncleaned bowl may prone to damage the movable parts in next use.

Add water in perfect ratio for perfect results

If you notice gearbox makes unusual noise, read on and find what could cause this and ways to solve it yourself.

If you notice gearbox makes unusual noise, read on and find what could cause this and ways to solve it yourself.

It could be that you have cleaned the gear drive with running water. It is strictly water-resistant attachment, If water has gone inside then it must damage the lubricant applied on small gears & internal parts.

To solve this, dry the gearbox in direct sunlight before next use.

If the above point does not help, then contact us.

Before running the product, please ensure as Jars are perfectly locked till last position on machine.

If the Jar is half locked, then it may result to damage the accessories like plastic parts, bowl and other parts.

If you notice any issue in Jar locking then, read on and find what could cause this and ways to solve it yourself.

Locking is very hard